Bikes

[hacksaw]

If anyone is interested 2013 T100 Less than 600 miles Top condition I bought new. Comes with still in the box triumph faring, Rear grab rail, stock seat and the rest of the stock stuff except the stock bars (which I might be able to recover ) Currently running Predator mufflers , aftermarket air filter, Norman Hyde bell mouth, triumph off road map and Thruxton bars/mirrors and old style Triumph logo top clamp with 1”? Riser spacers Had 500 mile service but that was some time ago No liens Price? Good question . I was offered a rediculous trade in of 3k+ trade in from national power sports . Cycle Trader has a few listed my year and low miles for over 5k. So I think I will eventually list it nationally at $5150 and see how that goes. I would consider a clean 85-2003 sportster in partial That’s the bike when new. CV doesn’t like my photos.

[hacksaw]

t-100 triump current roller project
1968, or maybe a 68 motor in an earlier frame. I would have to check .
Rebuilt bottom end including new morgo 750 kit.
Have likely 95% parts to complete it.
New emgo shocks new swing arm bearings
Head stock repacked . I can’t remember if I used the balls or a roller conversion. No title  

Again , I can’t post pics here


1962
 BSA 650
Roller.  new rebuilt  motor .
New carb , srm up grade crank bushing and oil pump . Single carb head . All rebuilt .everthing new!  Been test run
Has title.


Prices are in the 3200 range for either.
I have a file of all the work done.
Triumph was done by Don Porter  (rip)
Here in Ct
BSA motor done by Steve Warner outside of Austin Texas.
A good friend and well known in that area for brit bike work